Humidity and Temperature measurement

-

OBJECTIVE: To measure the humidity and temperature of surrounding using Humidity sensor with Arduino and then print the value on LCD display.      

Electronic Components you need for this project are:

1) Arduino Uno

2) DHT11 Humidity and Temperature sensor module

3) 16×2 LCD display

4) 10k Ohm potentiometer

5) 5kohm resistor

6) Power supply

7) Breadboard for connection

8) Connecting Wires

 

Link to the project site is given below:

Comments

Post a Comment

Popular posts from this blog

Smartphone Controlled Arduino Rover.

-
Image
Step 1: Parts and Tools Required Parts : 1. 4WD Robot Chassis kit (  GearBest ) 2. Arduino Nano ( GearBest  ) 3. LM298 H bridge Module ( GearBest ) 4. Bluetooth Module HC-06 (  Amazon  ) 5. 2 x 18650 Li Ion Battery (  Gear Best  ) 6. 2x 18650 Battery Holder (  Gear Best  ) 7. Mini Bread Board (  Gear Best  ) 8. 0.5 sqmm Wires 9. Male-Female Jumper Wires (  Amazon  ) 10. Male-Male Jumper Wires (  Amazon  ) 11. Duct Tape or any other tape (  Amazo For Obstacle Avoiding Robot : HC - SR04 Ultrasonic Distance Measuring Module (  GearBest  ). Tools Required : 1. Soldering Iron ( Amazon ) 2. Wire Cutter ( Amazon ) 3. Wire Stripper ( Gear Best ) 4.Glue Gun ( GearBest ) Step 2: What Is a Robot ? instructables circuits Open Menu Smartphone Controlled Arduino Rover By  opengreenenergy  in  Circuits Arduino 357,623 496 215 Featured Download Favorite Introduction: Smartphone Co...
Read more

How to Build a Robot Line Follower without a Controller

-
Image
In this tutorial I will show you how to make a simple line follower robot. Normally these type of robots use microcontrollers and complex logic to track and follow line. But today I will be showing you how you can make a simple line follower without a microcontroller. Before we start making the robot, let’s understand what a line follower is and how it works. What is a Line Follower? Line Followers are Automated Guided Vehicles (AGVs). These robots follow a line (black or white) using some logic. They’re mostly used to carry material around inside a factory. A microcontroller is like a brain of the robot that can be programmed to add unique features. But we don’t really need any coding knowledge or fancy microcontrollers to make this particular robot. How does it works? A line follower is an array of Infrared (IR) sensors. These sensors have a set of IR LEDs and Photodiodes. The LEDs emit infrared light on a surface (floor) and the Photodiode receives reflected light. The a...
Read more